User manual

78
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
Set Waypoint
Tap Create a Route, Waypoint flight, and then Set Waypoints to create a new flight route and edit
waypoints.
Tap on the map to add waypoints, then congure route and waypoints settings.
1. Point of Interest (POI)
: Tap to enable the POI function and a POI will be displayed on the map. Drag to adjust its
position. When the POI function is enabled, the drone yaw can be set to center to POI so that the
aircraft nose points at the POI during the mission. Tap this icon again to disable the POI function.
2. Reverse Path
S
E
: Tap to swap the start and end points to reverse the ight path. “S” refers to the start point.
3. Clear Waypoints
: Tap to clear all the added waypoints.
4. Delete Selected Waypoint
: Tap to delete the selected waypoint.
5. Parameters List
Edit the route name, set the aircraft type as M300 RTK, and congure the gimbal and camera.
6. Route Settings
The settings are applied to the entire route, including aircraft speed, height, aircraft yaw, gimbal
control, waypoint type, power saving mode and completion action.
7. Waypoint Settings
Select a waypoint and then set waypoint parameters. Tap “<” or “>” to switch to the previous or next
waypoint. The settings are applied to the selected waypoint, including aircraft speed, height, aircraft
yaw, waypoint type, waypoint actions, longitude and latitude.
8. Mission Information
Shows the flight length, estimated flight time, waypoint quantity, photo quantity, longitude and
latitude.
2
3
4
5
S
0000 m
00 m 00 s
Distance
Estimated Time
0000
Waypoints
0000
Photos
S
E
The building of mapping
Matrice 300
Gimbal III
X-Port
Gimbal II
Zenmuse Z30
Gimbal I
Zenmuse XT2
Tap and hold to adjust payload position
Select Aircraft
Flight Route Name
In-Flight（GPS）
19:29
GPS
12
2.4G
80%
100%
26.1v
26.1v
1
2
3
4
8
9
10
5
6
7