User manual
Table Of Contents
- Using This Manual
- Product Profile
- Aircraft
- Profile
- Flight Mode
- Flight Status Indicator
- Aircraft Beacons
- Aircraft Auxiliary Lights
- Vision System and Infrared Sensing System
- Return-to-Home (RTH)
- Center of Gravity Calibration
- Flight Recorder
- Propellers
- Intelligent Battery Station
- Intelligent Flight Battery
- DJI Intelligent Flight Battery Functions
- D-RTK
- DJI AirSense
- Expansion Ports
- IP45 Protection Rating
- Remote Controller
- Gimbal and Camera
- DJI Pilot App
- Flight
- Appendix
80
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
Gimbal I - H20T - wide
3
/12
a
f
b
d
e
c
In-Flight Editing
Enter the mission library, select a created ight route, tap
to start the mission, or tap to edit the
ight route.
1. Tap to enter In-Flight Editing page. The editions will be merged into the original route after saved.
2. Tap to enter Set Waypoints page.
3. Tap to enter AI Spot-check page.
4. Flight limit infomation
: Tap to see the ight limit information.
5. Location
: Tap to center the map around the aircraft’s location.
6. Map Lock
: Map rotation is locked by default. North is at the top. Tap the button to unlock rotation. Users
can adjust the map orientation by tapping and rotating two ngers on the map.
AI Spot-check can only be used with the H20 series payload in zoom camera view.
AI Spot-check takes photos at up to 10 times the focal length.
RTK should be used for photo capture and Planned Route ight of the AI Spot-check, and the
RTK base station coordinates of the photo capture and Planned Route ight must be the same.
AI Spot-check can support up to 750 photos.
The ratio of the selection box size of the photo to the area of the whole photo cannot be less
than 1/25 when using AI Spot-check.
The selection box position must be in the middle of the view and the size needs to be the
same as the target size.
If Advanced Dual Operator Mode is in use, Controller A must be used to complete the Demo
Flight and mission upload.
H20 and H20T gimbal and camera should be installed on the 1st gimbal port.