User manual

92
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
Starting/Stopping the Motors
Starting Motors
The Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom
inner or outer corners to start the motors. Once the motors start spinning, release both sticks simulta-
neously.
OR
OR
Stopping the Motors
There are two ways to stop the motors:
1. When the aircraft has landed, push and hold the left stick down. The motors will stop after three
seconds. (Recomended).
2. When aircraft has landed, push the left stick down , then conduct the same CSC that was used to
start the motors, as shown above . Motors will stop immediately. Release both sticks once motors
stop.
OR
Method 2Method 1
Flight Test
Takeo/Landing Procedures
1. Place the aircraft in an open, at area with the battery level indicators facing towards you.
2. Turn on the remote controller, then turn on the aircraft.
3. Launch DJI Pilot and enter the Camera View.
4. Wait until the Aircraft Status Indicators blink green (with single point positioning) or blink green and
blue alternately (RTK).
5. If the Intelligent Flight Battery temperature is low, use the self-heating function to heat the batteries to
ensure the temperature is suitable for the aircraft to take o.
6. Turn on the motors using CSC and push the left stick up slowly to take o.
7. To land, hover over a level surface and gently pull down on the left stick to descend.
Emergency Propeller Stop
The Combination Stick Command (CSC) can be used to execute the emergency propeller stop once
the ight controller detects critical error during ight.