User manual
Table Of Contents
- Using This Manual
- Product Profile
- Aircraft
- Profile
- Flight Mode
- Flight Status Indicator
- Aircraft Beacons
- Aircraft Auxiliary Lights
- Vision System and Infrared Sensing System
- Return-to-Home (RTH)
- Center of Gravity Calibration
- Flight Recorder
- Propellers
- Intelligent Battery Station
- Intelligent Flight Battery
- DJI Intelligent Flight Battery Functions
- D-RTK
- DJI AirSense
- Expansion Ports
- IP45 Protection Rating
- Remote Controller
- Gimbal and Camera
- DJI Pilot App
- Flight
- Appendix
98
©
2020 DJI All Rights Reserved.
MATRICE 300 RTK User Manual
Ofine Update
Oine Update is available when using DJI Pilot v.3.0.1.4 (M300) or later. An oine rmware package
can be downloaded from the DJI ocial website to an external storage device such as am SD card or
U disk. Run DJI Pilot, tap HMS, and then Firmware Update. Tap Oine Update to select the rmware
package of the remote controller, aircraft, payload, or battery station from the external storage device
and tap Update All to update.
Using DJI Assistant 2 for Matrice
For the remote controller, M300 RTK aircraft, H20 series and X-Port payload*, users can connect each
device to the software and then run a rmware update to update rmware on the devices accordingly.
Remote Controller Firmware Update
1. Power on the remote controller and aircraft. Connect the remote controller to a PC with a USB cable
with dual A-port.
2. Tap
to set as USB data export mode in the remote controller’s Quick Settings.
3. Click the corresponding device name and then the rmware update tag.
4. Select the rmware version required. Make sure to connect to the Internet when downloading the rmware.
5. Restart the device after the rmware update is complete.
Aircraft Firmware Update
1. Power on the aircraft. Connect the aircraft to a PC with a Type-C USB cable.
2. Run the DJI Assistant 2. Click the corresponding device name and then the rmware update tag.
3. Select the rmware version required. Make sure to connect to the Internet when downloading the rmware.
4. Restart the device after the rmware update is complete.
CSM Radar rmware updates are included with aircraft rmware updates.
H20 series Firmware Update
1. Install the H20 series payload onto the aircraft. Power on the aircraft. Connect the aircraft to a PC
with a Type-C USB cable.
2. Run the DJI Assistant 2. Click the corresponding device name and then the H20 series rmware
update tag.
3. Select the rmware version required. Make sure to connect to the Internet when downloading the
rmware.
4. Restart the device after the rmware update is complete.
The battery rmware is included in the aircraft rmware. Be sure to update all the batteries' rmware.
The aircraft battery level should be above 25% and the remote controller battery level should
be above 50% for the rmware update process.
Make sure all the devices are connected normally during update.
It is normal that the gimbal will go limp, the aircraft status indicator blinks abnormally when
the aircraft reboots. Wait patiently until the update is complete.
Make sure to keep the aircraft away from people and animals during rmware update, system
calibration and parameter setting.
Be sure to update the rmware to the latest version to ensure ight safety.
After the firmware update is completed, the remote controller and the aircraft may be
disconnected. If necessary, re-link them.
* Supported later.