Operation Manual

MATRICE 600

User Manual

The antennas are attached to the landing gear legs upon delivery. DO NOT move the

antennas. Pull out the antenna cables from the landing gear legs before mounting.

Mounting the Landing Gear

1. Insert one landing gear leg into each landing skid tube and ensure that the antenna is pointing in

the same direction as the screw hole on the landing skid tube. Secure the landing gear leg in place

by inserting and tightening the M3×8 (cylinder) screw. Be sure to insert the screws from right to left

as shown below to avoid damaging the screw holes.

2. Insert the landing gear leg into the connector on the retractable module. DO NOT damage the

antenna cable. Rotate the landing gear leg until its slots are aligned with the ns in the connector.

3. Pull the antenna cable through the landing gear stopper and insert the stopper into the connector

on the retractable module.

4. Insert two M3×8 (cylinder) screws into the screw holes on the connector and tighten. Be sure to

insert the screws from left to right as shown below to avoid damaging the screw holes.

5. Pull the antenna cable through the retractable module and then connect to the antenna extension

cable at the bottom of the center frame. Then move the antenna protector on the antenna extension

cable to cover the point of connection with the antenna cable.

Antenna

Antenna Cable

Fins in the Connector

Antenna Cable

Landing Gear

Stopper

Antenna Protector

Antenna Extension Cable

Antenna Cable