Operation Manual

DJI Assistant 2

When using your Matrice 600 for the rst time, activate it in the DJI Assistant 2 software.

Installation and Launching

1. Download the DJI Assistant 2 installation le from the ofcial DJI website:

http://www.dji.com/product/matrice600/info#downloads

2. Complete the installation for the DJI Assistant 2 software.

3. Launch the DJI Assistant 2 software.

Using the DJI Assistant 2

1. Ensure that all the six Intelligent Flight Batteries are fully charged and then install them.

2. Power on the remote controller, and then turn on one of the Intelligent Flight Batteries in the

aircraft. If other batteries are not triggered automatically, connect your mobile device to the remote

controller and go to the DJI GO app for information.

3. Connect the Micro USB port (at the bottom of the Aircraft Status Indicator) of the Matrice 600 to the

computer with a Micro USB cable. Do not disconnect the cable until conguration is nished.

4. When a connection is established, the software will display the connected devices: “M600” and

“Lightbridge 2”. Click the corresponding device to congure settings.

If the software doesn’t display both of the connected devices, check the USB connection

between the aircraft and the computer, and the driver on your computer.

M600

Activating the Aircraft

When using your Matrice 600 for the rst time, click on the “M600” icon and you will be prompted to

activate the aircraft on your computer. Follow the steps on-screen to activate the aircraft.

Basic Settings

GPS Mounting Position

If using the GPS module that comes with the Matrice 600 only, enter its mounting position into the

appropriate elds. The default values are the mounting position on the left of the center frame. Fill in

the values related to the aircraft’s center of gravity if mounting the module to another position.

Modular Redundancy System

If using the modular redundancy system, identify the module according to the number of times the

module’s LED blinks (e.g. If a GPS blinks once, it is “GPS1”). Then enter each module’s corresponding

mounting position into the appropriate elds. Ensure that the values are correct, or else the aircraft’s

positioning will be off.

DJI Device

If using the D-RTK GNSS, enter the antenna mounting positions into the appropriate elds.