Operation Manual

MATRICE 600

User Manual

4. Use a pin to press and hold the SET button while powering on one of the Intelligent Flight

Batteries, releasing the button when the battery powers on. The remaining batteries will power on

automatically (if the remaining batteries do not automatically power on, connect your mobile device

to the remote controller and follow the on-screen tips in the DJI GO app). The LED will blink yellow

quickly. Press the SET button again. Auto calibration will begin and the LED will blink yellow slowly.

DO NOT obstruct any moving parts during auto calibration.

5. During calibration, the left landing gear leg will raise and lower, followed by the right landing gear leg.

6. After calibration, both the left and right landing gear legs will be lowered and the LED will display a

solid green light. This indicates that the landing gear is working properly.

7. Connect both springs to the legs and the center frame.

If the LED is solid yellow after calibration, a problem has occurred. Ensure that the servos

are mounted correctly and then try again.

Avoid obstructions during calibration. If the landing gear was obstructed, recalibration will

be required, per the above steps.

If the “R” and “L” servo cables are reversed, travel will not be measured correctly. Fix the

connections and recalibrate the landing gear using the above steps.

Landing gear servo travel has been pre-calibrated. Mechanical adjustment of the servo

travel is not recommended.

LED Description

— Solid Green System normal

Blinking Green Rapidly Calibration required

Blinking Green Slowly Recalibration required

— Solid Yellow Calibration failed

Blinking Yellow Rapidly Enter calibration mode

Blinking Yellow Slowly System calibrating

— Solid Red Servo stalled

Blinking Red Rapidly Unsafe startup alert

Blinking Red Slowly Input signal abnormal

Specications

Operating Voltage 6S LiPo Input Signal PWM (High-Pulse Width 800 - 2200us)

Operating Current Max 1 A @ 6S LiPo Output Signal

PWM (Mid Position is 1520us) in 90

Operating

Temperature

-20° to 70° C Output Voltage 6 V

Total Weight 742 g Servo Travel 150° (Min 120°)