Operation Manual

MATRICE 600

User Manual

of the center frame, arrange the gimbal cables, and then re-mount the lower cover of the center

frame. DO NOT damage the cables.

4. Replace the original dampers of the gimbal with the new dampers in the accessory pack. Then

replace the original gimbal brackets with the new ones. Insert and tighten the eight M3x8 screws.

5. Mount the four new brackets to the expansion mounting rod at the bottom of the center frame.

Adjust the gimbal to the center of the aircraft. Then insert and tighten the four M3x8 screws.

6. Connect the other ends of the gimbal video cable (7-pin) and gimbal attitude cable (CAN) to the

corresponding ports on the Z15 series GCU.

7. Connect the XT30 connector of the power distribution cable in the accessory pack to the XT30

cable at the bottom of the center frame. Connect the other XT30 connector of the power distribution

cable to the power cable of the retractable module. Connect the XT60 connector to the power

cable of the Z15 series GCU.

The Z15 series gimbal cables are only for using the Z15 series gimbal with the Matrice 600.

DO NOT mix up the Z15 series gimbal cables with other cables.

Be sure to mount the gimbal to the center of the aircraft to avoid affecting ight performance.

Gimbal Connection Illustrator

Ronin-MX

CAN1

CAN1*

CAN

PWR HDMI

HDMI

VIDEO OUTGIMBAL

A3 Flight Controller

Lightbridge 2 Air System N1 Video Encoder

Ronin-MX SRW-60G Transmitter

SRW-60G Receiver

FPV Camera

When using the Ronin-MX, set the App Output Mode in the DJI GO app to display the image on your

mobile device from the camera used with the Ronin-MX. Launch the DJI GO app > Camera View >

> Disable EXT Port, adjust the Bandwidth Allocation to ensure that the “HDMI” percentage is

more than 0%, and then set the App Output Mode to HDMI.

*You can connect the CAN cable to

the CAN Hub on the GPS cable.