Getting Started Guide

To remove the lower quick-release plate, toggle the lever on the camera mounting plate to the
unlocked position and remove the lower quick-release plate while pressing the safety lock on the
mounting plate.
4. Connect the Camera Control Cable.
Choose the proper camera control cable according to the camera type. Plug one end of the cable
into the RSS camera control port of the gimbal and plug the other end into the camera.
Balancing
Balancing is required before shooting. Before balancing, make sure to power on the camera if using
an optical zoom lens and to select the focal length if using a varifocal lens. Make sure DJI RSC 2 is
powered off or in sleep mode before balancing.
1. Balancing the Vertical Tilt
a. Unlock the tilt axis and loosen the mounting plate knob.
b. Rotate the tilt axis so that the camera lens is pointing upward. Check to make sure the camera
is not top or bottom-heavy. If top-heavy, move the camera backward. If bottom-heavy, move the
camera forward.
c. Tighten the mounting plate knob while holding the camera upward. The vertical tilt is balanced
when the camera is steady while pointing upward.