User manual

3 Remote Controller

The PHANTOM 2 remote controller can be configured in the PHANTOM RC Assistant. The sticks mode is Mode 2

on delivery.

For upgraded remote controller (models: NDJ6 or NRC900), select “Upgrade Version” in Phantom Assistant.

For basic remote controller (models: DJ6 or RC900), select “Basic Version” in Phantom Assistant.

[1]

[2]

[5]

[4]

[9]

[10]

[7]

[8]

[6]

[3]

[11]

[12]

[13]

[14]

Figure 3-1 Figure 3-2

[1]Antenna [2]Carrying Handle [3]Left Dial [4]3-Position Switch S1 [5]3-Position Switch S2 [6]Joystick1(J1;J2)

[7]Joystick2(J3;J4) [8]Neck Strap Attachment [9]Power Switch [10]Power Indicator

[11]Battery Level Indicators LED1/LED2/LED3/LED4 (from left to right) [12]Trainer Port

[13]Battery Charge & RC Assistant Port (micro-USB port) [14] Potentiometer

3.1 Power on the Remote Controller

1. Set the S1 and S2 switches to the upper most position and ensure both joysticks are at

the mid-point position. Then toggle on the power switch.

2. Push the power switch to the right to power on the remote controller. If the power LED

indicator is solid on, the remote controller is functioning normally. The battery level

indicators display the current battery level.

1. Please make sure the battery level of remote controller is enough. If the low voltage warning alert

sounds (refer to <Remote Controller Power LED Indicator Status>), please recharge the battery as soon

as possible.

2. Charge the remote controller’s battery by using the included micro-USB cable. Using the incorrect

type of charging cable may cause damage.

3. Turn off the remote controller before charging. The power LED indicator will display solid red when

charging is in progress. The LED indicators will display solid green when the battery is fully charged.