User manual

©2013-2015 DJI. All Rights Reserved.18 |
The left dial controls the pitch of the H3-2D and H3-3D
gimbal. The position of left dial determines the pitch
angle relative to the horizontal level.
Turn the left dial to the right to make the gimbal pitch
up.
Turn the left dial to the left to make the gimbal pitch
down.
The gimbal will keep its current position if the dial is
static.
（1） For ‘Ready to Fly’ the aircraft will hover when all sticks are released.
（2） For ‘Ready to Fly (non-GPS)’ the aircraft will only keep the altitude when all sticks are released.
3.5 Linking the Remote Controller & Built-in Receiver
PHANTOM 2 has a built-in receiver, the link button and indicator located on the bottom of the aircraft as illustrated
in the Figure 3-4.
The link between the remote controller and aircraft is already established for you so you can initially skip this
procedure. If you ever replace the remote controller, re-establishing the link is required.
Link button &
Link indicator
Figure 3-4
Linking procedures
1. Power on the PHANTOM 2.
2. Turn on the remote controller and place it 0.5m~1m away from the aircraft.
3. Push the link button with a thin object and hold it until the Link indicator blinks red, then release it.
4. When the Link indicator turns solid green, the link between the remote controller and the built-in receiver
has been successfully established.
Link Indicator
Status
The remote controller is turned off and there is no 2.4GHz signal around, please turn
on the remote controller.
The receiver is ready for linking.
There is 2.4GHz signal around but the remote controller is not linked with the receiver,