User manual

Remote Controller
28
©
2017 DJI All Rights Reserved.
Phantom 3 SE User Manual
Linking the Remote Controller
The Phantom 3 SE is linked to the remote controller by default, and re-linking is only necessary if the
remote controller is replaced with a new one. Refer to the gure below to locate the Link Button.
Link Button
Linking Procedures
1. Turn on the aircraft and press the Link Button. The button will blink red when the aircraft is ready to link.
2. Switch on the remote controller, turn the gimbal dial to the far left, and toggle the S2 switch back and
forth quickly for at least three times. You will hear a pulsating beep sound when the remote controller is
trying to link to the aircraft.
3. The remote controller will stop beeping and the Link Button on the aircraft will turn solid green if linking
is successful.
Linking Status
Link Button Description User Action
— Glows solid red No RC signal Switch on the RC or perform a linking procedure
Blinks red Ready to link Switch on the RC
— Glows solid green Linked to RC Linking successful
Remote Controller Compliance Version
The remote controller is compliant with FCC, SRRC and CE requirements.
Position 1
Position 3
Switch S2