Operation Manual

Ronin-MX User Manual
©
2016 DJI All Rights Reserved.
21
Without causing any vibrations or oscillations, (1) Increasing the Strength value will
reduce gimbal attitude errors; (2) If the gimbal experiences high frequency vibrations,
increase the Outfilter value, otherwise it should be set to 0; (3) Increasing the Control
value will compensate for angular vibrations.
Do not adjust the default Strength, Outlter or Control values unless you are an advanced
user.
2. SmoothTrack Mode
Refer to the Basic Settings section for details relating to SmoothTrack Mode.
3. Push Mode
Enable Manual Adjustment to allow the pan and tilt axes to be adjusted by hand when the
Ronin-MX is turned on.
The trim adjustment controls the amount of trim that is applied to each off-centered axis.
The default setting for the center is 0˚.
Control Menu
1. Deadband
The Thumb Controller and the remote operator controller can have independently
adjusted pan and tilt deadband settings. The larger the deadband, the more stick
movement will be required to translate into actual movement of the gimbal.
2. Maximum Speed
Maximum Speed is a function that prevents the control stick response from being a linear
response, which is also known as an increasing response curve. This means the amount
that the gimbal moves on the pan or tilt axis is not directly proportional to control stick
manipulation. Control stick response can be adjusted to be milder below the rst half of the
control stick’s travel and increased to a higher speed towards the last half of the control
stick’s travel. The preset exponential curve is calibrated based on maximum speed input.
The maximum speeds of the Thumb Controller and the Remote Controller sticks can be
set independently of each other.
Gimbal Control Viewer More
N/A
Mode：
Wizard
Control
Deadband Maximum Speed
Smoothing Endpoint
Channels Settings
？
Gimbal Control Viewer More
Deadband Adjustment
Thumb
Controller
Remote
Operator
Pan
Tilt
Control
Deadband
6
6
6
6
？
Gimbal Control Viewer More
Control Speed Adjustment
Thumb
Controller
Remote
Operator
Pan
Tilt
Control
Maximum Speed
40
15
15
15