User Manual

©2012 DJI Innovations. All Rights Reserved. 20
Working Modes/HDMI/AUX2/AUX3 Switch Setup
Gimbal Working Mode Switch Set
Whichever 3-position switch selected as working mode switch, wire the right channel of receiver to MODE
port. At each switch position, use end-point fine tuning, set the channel AUX2(JR) /7(Futaba/Hitec) for the
three Working modes.
Orientation-locked Mode MODE channel end-point 60%~90%
FPV Mode (Reset) back to center
Non orientation-locked Mode MODE channel end-point 60%~90%
Notices:
 The gimbal will work in Orientation-locked Mode, if not connect to MODE.
 Gimbal default works in FPV Mode after power on.
 The gimbal will maintain the Working Mode from last moment, if the cable between MODE and RC
receiver is disconnecting while working.
Tips:
 For 3-position switch, you may assign:
Position-1 to Non orientation-locked
Position-2 to FPV Mode (Reset)
Position-3 to Orientation-locked
Position-1 and Position-3 can be reverse assigned.
 One 2-position switch can be assigned for any two of the working modes as you like.
HDMI Switch Set
HDMI-AV module can be set on/off by TX. Please ensure camera HDMI port is connected to gimbal correctly.
Whichever 2-position switch selected as HDMI switch, wire the right channel of receiver to AUX1 port.
You may assign: Position-1 to ON; Position-2 to OFF; or reverse the assignment.
Notices:
The camera HDIM will be on if AUX1 and RC receiver is disconnected.
Tx
1
2-position
switch
2
Tx
1 2 3
3-Position
Switch