Operating instructions

TransTel TD-1648i / TDS-600 Programming Manual
101
29- XX -03 - ISDN I NCOMING C ALL T YPE :
This feature allows the user to set ISDN line to fit different incoming call types.
0 = InBlock Sending. The ISDN Central Office will send “Extension Called Party Number” or “Extension Sub-
address Number” during the setup procedure.
1 = Overlap Sending. The ISDN Central Office does not send “Extension Called Party Number” or “Extension
Sub-address Number” during the setup procedure. After the setup procedure has been established, this
information will be sent by Central Office.
2 ~ 9 = MSN. System rings the extensions assigned in Program 01/Program 02 when there is an incoming
ISDN call.
29- XX -04 - S ET R INGING T ONE :
This feature allows each trunk to ring at DK telephone sets with its own individual ring frequency and override
the frequency set by the user for all calls.
0=Use station’s default ring 1-8=Use assigned trunk ring cadence
29- XX -05 - I NCOMING C ALL C ONNECT :
This feature allows either some or all stations which are ring assigned in Mode 01 or 02 to receive the audible
ring signal when a trunk rings at the station. If the audible signal is disabled the station will still be able to
answer a call by lifting the handset only, if they are ring assigned in Mode 01 or 02
0=Ring All 1=Ring first station 2=Ring first two stations
3=Ring first three stations 4=Ring first four stations 5=Ring first 5 stations
6=Ring first 6 stations 7=Ring first 7 stations 8=Ring 8 stations
9=Ring first 9 stations
Example: If there are 12 stations programmed on Form 01-01 and 29-01-05 is set to a value of 5, the first five
stations will ring, but all twelve stations will be able to access the incoming line simply by lifting the handset.
29- XX -06 - 1A2 E MULATION :
When an extension is connected to a trunk, another extension can make a conference by press the busy trunk
button if 1A2 Emulation is available. The actual operation of this parameter is dependant upon interaction with
Form 78-ST-03, described elsewhere in this manual.
0=No Trunk Access 1=Access Conditional upon 78-STN-03
The 1A2 Emulation status is shown below:
29-xx-06 78-St-03 Status
0 N/A No access
1 0 No access
1 1 access with tone
1 2 access with no tone
Even if 1A2 Emulation status is enabled, the extension can temporarily disable 1A2 emuation by pressing
Function key: [1A2 Emulation Privacy] – (FN:24 for DSS key in Form 07). When the extension sets 1A2
Emulation Privacy Key, the key LED will light, and other extensions can't enter the call. The extension can press
[1A2- Emulation Privacy] again to cancel 1A2 Emulation Privacy and turn the key LED off.
Related System Programming Mode: 07, 29-TK-06, 78-ST-03