Operating instructions

TransTel TD-1648i / TDS-600 Programming Manual
105
Form 36 - CO Line Groups (Dial 9 Groups)
General:
This program permits each line to be assigned to different line (trunk) groups. There are eight groups in total.
Description:
In the bottom data-setting area, the line number (01-16) means that the trunk is included in the specified group.
Press [REDIAL] to clear all entries from the table before entering the required trunks. It is recommented to
always set outgoing calls to start from the highest installed line and program in descending order to the lowest
line. This will prevent call collision particularly in systems with SLT'S where line selection is by access code
rather than direct line button access..
There are 16 trunks maximum in a trunk group.
This parameter will work with the following features:
. Dial 9 or 0 access to trunk group.
. Tenant service.
Related System Programming Form: 36, 38, 41-ST-04, 46-ST-01