Operating instructions

112 Issue 1.0 March, 2006
Form 42 - Personal Speed Dial Table Assignment
Default Numerical -01 DSS -02
42-___-
42-st-IP SPD-T
b1 b2
st = Station No. (2-4 digits) IP = 01-02
blocks (2 max.) for a Station
b1: Block 1 of Individual Speed Dial Codes (00-09 or DSS11~DSS20)
b2: Block 2 of Individual Speed Dial Codes (DSS1-10)
General:
This program divides sets of Individual Speed Dial into blocks for use by Stations.
Description:
 If in program 05-04-06, the Individual Speed Dial Codes are assigned:
500 sets, the maximum blocks in this program are 50 blocks.
400 sets, the maximum blocks in this program are 40 blocks.
300 sets, the maximum blocks in this program are 30 blocks.
 Each block has 10 sets of Individual Speed Dial.
 Each set has up to 30 digits.
 Speed Dial Codes 00~09 shares the same memory block with DSS11~DSS20.
 Each Station can use up to 2 blocks (20 sets of Individual Speed Dial.)
Example:
42-13-IP SPD-T
01 02
13: Station No. ( 2-4 digits )
01 02: Station 553 can use block 01 and 02 for Individual
Speed Dial (20 sets)
42-15-IP SPD-T
04 00
15: Station No. ( 2-4 digits )
04 00: Station 105 can use block 04 (10 sets) for Individual
Speed Dial (00-09 or DSS11~20), 00 : for no block.
42-18-IP SPD-T
00 03
18: Station No. ( 2-4 digits )
00 03: Station 550 can use block 03 for Individual Speed Dial
(DSS 1-10)
* Refer to Keyphone Operation for the programming of Individual Speed Dial.
* Be sure to program these parameters before programming speed dial on key phones.
If problems are encountered with stations not being able to program speed dial numbers, check this parameter to
be sure that speed dial locations are available to the station. If the station card was installed at the time of
system initialization then the blocks will have been allocated automatically.