Operating instructions
114
Issue 1.0 March, 2006
43-
PORT
-03
–
DSS
K
EY
G
ROUP
A
SSIGNMENT
:
This parameter is only of value if the device connected to the port is a DSS console. This number refers to the
DSS key group to which the DSS will belong. DSS key group assignments (key maps) are configured on Form
08
-
group
-
key. Please see Form 08 for more details.
1 = Key Group 1 2 = Key Group 2 3 = Key Group 3 4 = Key Group 4
5 = Key Group 5 6 = Key Group 6 7 = Key Group 7 8 = Key Group 8
43-
PORT
-04
-
A
SSOCIATED
S
INGLE
L
INE
T
ELEPHONE
:
This parameter is used on Display Digital Telephones that are equipped with an internal Single line
adapter. When equipped the SLT and digital telephone may operate in conjunction with one another.
0=SLT Device operates independently from the digital telephone. No association exists between the
two devices.
1=Auto call forward digital key telephone to single line telephone.
2=Enable pickup key, allowing digital telephone to capture an existing phone call from the single line
telephone port.
3= Enable 1 & 2 above.
Programming Station Name. Entries may be programmed on this form. Select the STN number that
you wish to program, press [CHANGE] (MIC/AT) key. During name entry, the numeric keypad
keys will operate as alphabetical character keys. Each key will enter the letters that appear on
the keycaps. The following table illustrates the entries that each key can make.
Each character is indicated in order. For instance, pressing 2 will display A. Pressing it again will display B.
Pressing it a third time will display C. Pressing it for the fourth time will display 2. The character that is being
programmed will be underscored. Movement from character to character (left to right) is through the use of the
DSS3 – (left) and DSS4 - (right) keys.
Key Pad
Depress
1 time
Depress
2 times
Depress
3 times
Depress
4 Times
Depress
5 Times
1 , . : 1 Space
2 A B C 2 ;
3 D E F 3 /
4 G H I 4 _
5 J K L 5 -
6 M N O 6 '
7 P Q R S 7
8 T U V 8 +
9 W X Y Z 9
0
0
* % ^ & * (
# $ ! @ # )
DSS Key 3 = Cursor Left DSS Key 4 = Cursor Right
When the name is acceptable, press [SAVE] to store the name in system memory.
To remove an existing name from the system, press [REDIAL]. This will clear all characters from the entry.