Operating instructions

TransTel TD-1648i / TDS-600 Programming Manual
117
Form 45 - Station Class of Service (Part 3)
Item
Valid
Settings Description Default
45-st-01 0-1 Intercom Call Limitation 0=Disable
45-st-02 0 Reserved 0
45-st-03 0 Reserved 0
45-st-04 0-1 Trunk Access 0=Enable
45-st-05 0-1 Inter-Group Station to Station Calls 0=Enable
45-st-06 0-1 Receive Break Alarm 0=Enable
45-st-07 0-1 Allow Unrestricted Speed Dial 0=Enable
45-st-08 0-1 Record Station's SMDR Data 0=Record
45-st-IP STCOS
0 0 0 0 0 0 0 0
st = Station No. (2-4 digits) IP = 01-08
System Default
45- EXT -01 - I NTERCOM D IALING R ESTRICTION :
If this setting is enabled, the station can not make an intercom call by dialing a station number. Under this
condition, the Key Phone still can press a Flexible Key to make an intercom call or the Key Station or
Analogue phones can call a station using the "Single Digit" feature.
0=Disable 1=Enable
45- EXT -02 - R ESERVED :
45- EXT -03 - R ESERVED :
45- EXT -04 - T RUNK A CCESS :
If this function is disabled then the station will be unable to access any trunks for incoming or outgoing calls.
0= Enabled - Trunk Access Allowed 1=Disabled - Trunk Access Disallowed
45- EXT -05 - I NTER -S TATION G ROUP C ALLING :
If this function is disabled then stations will not be able to make intercom calls outside their own station group
(Form 41-st-01). This parameter is for use in tenant arrangements where each company wishes to remain
totally separate although some stations can still be allowed this function, for instance a shared Receptionist.
0=Enable 1=Disable
45- EXT -06 - R ECEIVE A LARM :
If this parameter is disabled then the station will not receive the Alarm signal if one has been programmed in
Form 39.
0 = Enabled – Receive Alarm 1 = Disable – Do not Receive Alarm