Operating instructions

TransTel TD-1648i / TDS-600 Programming Manual
119
Form 46 - Station Class of Service (Part 4)
Item
Valid
Settings Description Default
46-st-01 0-8 Dial [87] Trunk Group 0= None
46-st-02 0-9 Send Message Wait Signal Level 1= Low
46-st-03 0-2 Automatic Answer Capability / Internal CLIP 0
46-st-04 0-7 DISA Recall Capability 3= Recall
46-st-05 0-9 Maximum Number Of Transfer Times Allowed 0= No Limit
46-st-06 0-7 Door Unlock/DND/CFWD Access 7= Yes
46-st-07 0-9 Call Forward No Answer to Assigned Hunting Group 0= Disable
46-st-08 0 Reserved 0
46-st-IP STCOS
0 1 0 3 0 7 0 0
st = Station No. (2-4 digits) IP = 01-08
System Default
46- EXT -01 - D IAL 87 L INE G ROUP :
If this setting is from 1 to 8, after the station dials [87], the system will automatically search for a free line
which is assigned in group 1 to 8 in Program Form 38.
0=Disabled 1-8=Group Number
Related System Programming Mode: 36, 38, 41-ST-04, 46-ST-01
46- EXT -02 - M ESSAGE W AITING L EVEL :
The Stations assigned higher levels can leave message for stations with the same or lower levels. Ten levels
(0-9) are available (9=highest level, 0=lowest level cannot leave messages).
0=Cannot leave messages
1-9 -Able To leave messages for stations of equal or lesser Message Waiting Level
46- EXT -03 - A UTOMATIC A NSWER C APABILITY (D IGITAL T ELEPHONE S ETS ):
This parameter if enabled will automatically switch on the microphone of the station if it receives an intercom
call. This setting is independent of whether the system is set to voice or ring signaling for intercom calls.
0 = No 1 = MIC permanently on
2 = MIC will switch on for Intercom calls
46- EXT -03 - C ALLER ID TO S INGLE L INE STATIONS : (When Connected to TD-SLC1 card):
This enables system to send different internal Caller ID signals to single line telephones.
0 = Disable Caller ID
1 = Enable to send SDMF(number without name)
Caller ID to the single line telephone
2 = Enable to send MDMF(number with name) Caller
ID to the single line telephone