Operating instructions

Access Control Phone Operation Manual
Intercom (as doorphone)
Operation:
1. Press to call the associated hunt group and open the door; or
2. Dial extension number, then press to call an individual extension to answer and open the
door.
Note: calls the hunt group according to TD-824i system settings:
ACP Hunt Group Routing - See Programming Form 46-st-07 (0-9 = Group 1 - Group 10)
Hunt Group Pilot Number - Form 67-GP (GP = 01-10)
Hunt Group Members - 68-GP-01-05 (GP=01-10)
Outgoing call (as wall mount phone)
Operation:
1. Press [9] to access an outgoing trunk.
2. Press to disconnect and return to idle.
Note: Auto-answer is available for both intercom and in-coming call.
Access via password
Operation:
Press
+ [7] + [password] + [#] to open the door (Display will show ‘PASS’)
Note: On invalid password, ACP will play busy tone for 5 sec and display will show ‘ERR’.
Access via proximity card(Touch-N-Go)
Operation:
Use the registered and authorized card, touch and go (Display will show ‘PASS’)
Note: On invalid card, ACP will play busy tone for 5 sec and display will show ‘ERR’.
Access via password and proximity card
Operation:
[Touch the card] + [password] + [#] to open the door (Display will show ‘PASS’)
Note: On invalid password or card, ACP will play busy tone for 5 sec and display will show ‘ERR’.
Check out (lock) ACP (as wall mount phone)
Operation:
1. + [8] + [password (3-digit)] to lock up ACP (as wall mount phone) to prevent it from use by
others.
2. + [#] + [password (3-digit)] to un-lock ACP (as wall mount phone) for temporary use
(making a call) by the owner. After the use, ACP is locked up again.