Operating instructions

TransTel TD-1648i / TDS-600 Programming Manual
35
Digital Key Telephone – DK1 Series, DK2 Phones and DSS Console
 Terminate the station wires with the connectors that are provided. The stations will connect to the G2-STU
of KSU using the center two pins only (pins 2 - 3).
 Connect Tip terminal with GRN terminal (screws) of the modular jack, Ring with RED.
 There is no polarity requirement on Tip and Ring.
 2-conductor wiring is required for DK1 and DK2 Digital Key Telephones.
 DSS Consoles must be connected as the second station. When a DSS is connected, the alternate device on
the pair must be configured as the first station.
 On DK-1 telephones, open the overlay covering the function key and select the 1
st
or 2
nd
station. Dip switch
to the right for the 1
st
station. Dip switch to the left for the 2
nd
station. If you change the switch setting, it is
necessary to unplug the telephone and plug it back in to reset to the alternate port.
 On DK-2 Telephones, The recessed pushbutton cycles the telephone between the 1
st
and 2
nd
station. This
should be done with the telephone plugged in to the circuit
Dip to right: the 1
st
station.
Dip to left: the 2
nd
station.
CAUTION!: Avoid shorting Tip and Ring together. It may damage the G2-MBU or G2-STU board.