Operating instructions

TransTel TD-1648i / TDS-600 Programming Manual
55
Form 05-03 - System Parameters Form - Codes-1
Form 05-03- 01 02 03 04 05 06 07 08
Code
Range Of Entries 0 - 1 0 - 1 0 - 1 0 - 9 0 - 9 2 - 4 0 - 1 0 - 9
Default
1 0 0 9 0 2 0 9
Item
Valid
Settings Description Default
05-03-01 0-1 Make / Break Ratio 1=40/60
05-03-02 0-1 Automatic Trunk Search 0=Allowed
05-03-03 0-1 Intercom Call Signaling Method 0=Voice Signaling
05-03-04 0-9 PABX (Centrex) Outgoing Code 9=9
05-03-05 0-9 Toll Access Code 0=0
05-03-06 2-4 Station Numbering Plan 2=2
05-03-07 0-1 Intercom Dial Tone Pattern 0=Steady
05-03-08 0-9 Door Phone Ringing Frequency 9= Background Music
05-03-01 - P ULSE D IAL - M AKE / B REAK R ATIO D IAL P ULSE R ATIO :
This permits the selection of a Make/Break Ratio for Dial Pulse signaling
0=33/67 1=40/60
05-03 02 - A UTOMATIC CO L INE S EARCH D URING S PEED D IAL , A UTO R EDIAL , S AVED R EDIAL , ETC .:
This allows the system to search for an available trunk according to the assigned dial 9 trunk group
when automatic dialing features are used; i.e., Speed Dial, Save Redial, Redial, etc.
0=Enabled (Allowed) 1=Disabled (Not Allowed)
05-03 03 - I NTERCOM C ALL S IGNALING TO E LECTRONIC T ELEPHONE S ET :
This selects the Intercom calling method. The user can still override this selection by dialing 3 after
initiating an intercom call. Individual stations can be set to automatic microphone switch-on in mode
46-st-03 and thus override the system wide ring method.
0=Voice Signaling 1=Ring Signaling
05-03-04 - PABX (C ENTREX ) O UTGOING C ODE (R EFERENCE F ORM 35-CO-01):
This parameter assigns the PABX outgoing call access code for Redial and Save Redial when the
system is installed behind a PABX.
It is used only when Trunk Lines are set to be PABX lines in Mode 35-TK-01.
This assignment also enables the system to identify whether the user's dialing is a PABX's Intercom call
or an Outgoing call for toll restrictions. (Refer to Program 35-TK-01)
0=0 1=1 2=2 3=3 4=4
5=5 6=6 7=7 8=8 9=9