Operating instructions
60
Issue 1.0 March, 2006
05-05-05
-
N
AME
F
UNCTION
:
This parameter enables the naming feature for trunks, extensions and speed dials.
Features \ Values 0 1 2 3 5 7
Display Name instead of number
for Extension
V V V V
Directory Dial for Speed Dial V V V
Directory Dial for Extension V V
V: The feature is enabled.
Note 1: When any of the above features are enabled the total number of speed dial sets will be
reduced by 300. See Mode 05-04-06.
Note 2: For setting name for Extension/Speed dial/Trunk, Please refer to the programming mode 43 /
09 /35.
Note 3: For setting “Directory Dial” key, Please refer to mode 07.
0=No Names Used 1=Display Names for Extensions
2=Name Speed Dial. (Allow Dial by Name
Speed Dial only)
3=Name Extensions & Speed Dial (Dial by Name)
5=Name Display and Dial by name for
Extensions only
7=Enable Name display and speed Dial. Enabled
Dial by name for Extensions and Speed Dial
05-05-06
-
D
IAL
T
ONE
D
ETECTOR
:
If setting is enable, then the system will send out the dialing signals after the system detects the Dial
Tone which is sent from the exchange, if dial tone is not detected by the system then dialing signals
will not be sent out. If setting is disable, then the system will send out dialing signals whether Dial Tone
is detected or not.
0 = Enable 1 = Disable
05-05-07
-
A
UTO
R
EDIAL
A
TTEMPTS
:
This parameter is to set the number of auto redial times which the system will attempt.
0=Disabled 1=3 Attempts 2=6 attempts 3=10 attempts 4=20 attempts
5=30 attempts 6=40 attempts 7=50 attempts 8=60 attempts 9=70 attempts
05-05-08
-
A
UTO
R
EDIAL
I
NTER
-C
ALL
T
IMER
(
SECONDS
):
This parameter is the time duration between the system hanging up an auto redial attempt and starting
to redial automatically
.
Off Hook
Auto-Redial Pause Time
(Program 05-05-08), Y
seconds
Off Hook
Auto-Redial Ringing Timer
On Hook
Auto-Redial Ringing Timer
0=10 1=20 2=30 3=40 4=50
5=60 6=70 7=80 8=90 9=100