Operating instructions

62 Issue 1.0 March, 2006
05-06-04 - P OLARITY R EVERSE D ETECTION :
This parameter is to enable the Polarity Reversal detection feature for incoming caller hang up
detection in Australia and some European countries. See Mode 14-01-08 for SMDR setting.
Telecom will need to enable polarity reversal at the exchange. When reversal is enabled the
system will hang up the exchange line when the incoming caller hangs up and the exchange sends
a reversal to the system.
0 = Disable
1 = Enable for 1 polarity reverse signal
2-9 = Delay for 1-8 Seconds and then detect Polarity Reverse Signal
In North American applications this is not used. Leave it set to 1.
0=Disable 1=Enable
05-06-05 - O PERATOR A CCESS C ODE :
This parameter is to set whether to dial "0" or "9" for the operator or for accessing a CO. line.
0 = 0 Operator - 9 Outside Line 1= 9 Operator - 0 Outside Line
05-06-06 - CO D ISCONNECT T IMER FOR ECF, U NSUPERVISED C ONFERENCE , AND DISA:
This parameter sets the time that the system will allow an Unsupervised Conference or External
Call Forward to continue before sending a warning tone to the parties and then disconnecting the
call.
If either party sends a DTMF digit (0-9) to the system the timer will reset and allow the call to
continue for the time setting. If reversal supervision is used it will override this setting.
0=Disable 1=1 minute 2=2 minutes 3=3 minutes 4-9=4 minutes
05-06-07 - S INGLE L INE T ELEPHONE H OLD P ROCEDURE :
This parameter is to set whether Single Line Telephones use [FLASH] (or [Hook-switch]) or
[FLASH, 7] (or [Hook-switch, 7]) to place a call on Hold.
0=Flash only 1 +[7=Flash]
3=Flash +[7] (System returns
tone after Flash)
05-06-08 - S TATION H UNTING G ROUP R ING M ETHOD :
This parameter sets the ring method used in the station hunting groups. Pilot numbers for hunt
groups are set in Mode 67 and Day/Night ring stations are set in Mode 68 & 69. This system wide
parameter can be overridden by programming in Form 67-GP.
0 = Common 1 = Linear 2 = Circular