Operating instructions
TransTel TD-1648i / TDS-600 Programming Manual
67
05-08-04
-
DISA
O
PERATOR
R
ECALL
L
OCATION
(N
O
A
NSWER
):
This parameter decides to which Console group an unsuccessful DISA call will be transferred if
the called station has transfer enabled in 46-st-04.
0=Console for the Called Station's group (41-st-01)
1=Console for the Incoming Trunk's group (36-gp)
05-08-05
-
SLT
F
EATURE
P
ROGRAMMING
A
CCESS
C
ODE
F
IRST
D
IGIT
:
This feature changes the programming digit used by an Analog phone to perform its
programmable features. For example call forward is normally 701, If this parameter is set to 3 the
call forward code will be 301. If the setting is 0 then the analogue phones cannot do programming.
If the setting is 8 it is necessary to press [*][#] before accessing programming or dialing any 8
codes. This will allow the use of digits 1 to 8 as the first digit of a station number
0=Disabled 1=1 2=2 3=3 4=4
5=5 6=6 7=7 8=[*][#][7]
05-08-06
-
DISA
N
O
A
NSWER
R
ECALL
T
IMER
(
SECONDS
):
An incoming call is answered by the DISA voice message and transferred to the called extension.
If the called extension does not answer after this time duration the voice card will announce the
status of the station (no answer). Or if the station is busy will announce the status (busy)
immediately and then retry the station the number of times set in Mode 05-11-06 and depending
on the settings for individual stations in Mode 46-st-03 will also transfer the call to the console of
the group specified in Mode 05-08-04, transfer the call to the console only or disconnect the call.
0=8 1=16 2=24 3=32 4=40
5=48 6=56 7=64 8=72 9=80
05-08-07
-
DISA
T
RANSFER
T
IME
(N
O
D
IGITS
D
IALED
)
T
RANSFER TO
C
ONSOLE
:
This parameter sets the time that a DISA call will wait after the voice message is completed before
transferring to the console if no digits are dialed by the caller. Do not set this to less than about 3
seconds for normal operation
0=Immediate 1 = 1 second 2 = 2 seconds 3 = 3 seconds 4 = 4 seconds
5 = 5 seconds 6 = 6 seconds 7 = 7 seconds 8 = 8 seconds 9 = 9 seconds
05-08-08
-
M
USIC SOURCE SELECTION
:
This parameter sets the Music Source for the Internal Background Music and CO Music on Hold
and Doorphone Ringback Tone.
Set Data B.G.M M.O.H Doorphone Ringback
0 Melody IC Melody IC Melody IC
1 External Source Melody IC Melody IC
2 Melody IC External Source External Source
3 External Source External Source External Source
4 Melody IC External Source SLT Music Port
5 External Source External Source SLT Music Port
6 Melody IC Double Beep Tone Silence