Operating instructions

76 Issue 1.0 March, 2006
05-12-05 - V OICE M AIL I NTEGRATION T YPE :
This parameter selects between Standard Voice Mail Call Forward Protocol and the Digit+ Extension protocol.
For a full description of Voice Mail Protocol see Mode 05-10. This parameter will also enable or disable muting
of the leading digits to the outside caller.
0=Use Form 05-10 DTMF Not Muted 1=Use Digit + Extension spec. DTMF Not Muted
2=Use Form 05-10 DTMF Muted 3= Use Digit + Extension spec. DTMF Muted
4=Same as 0. 5= Use Digit + Extension spec. Not Muted. Does Not
send Direct CO Call Code
6=Same As 2 7= Use Digit + Extension spec. DTMF Muted. Does
Not send Direct CO Call Code.
05-12-06 - T RUNK G ROUP A CCESS T YPE :
If this parameter is set to 0 then line selection will be the first available trunk in the users dial (9-0) group. If the
parameter is set to 1 then the lines will be selected in a Circular fashion till all lines have been used and then
the selection will start again. Do NOT use Circular with CO lines unless there is a very good reason as call
collision is more likely to occur as a result.
0=Linear Hunt 1=Circular Hunt
05-12-07 - LED INDICATION OF C HECK IN / C HECK OUT :
This parameter disables or enables the LED indication for Check in/Check out features for the DSS consoles
and DSS Keys
The LED indications are as follows:
Red and slow flash: If the Reception has checked out an extension, the LED for extension will
slow flash red.
Green: When the checked out extension’s room has been cleaned by the
cleaner(maid), they can dial [776] from the phone and hang up. The LED for
that extension will go Green. This means the room is ready for a new guest
Red: The room is checked in and the phone is in use.
Off: The room is checked in and idle.
0 = Disable 1= Enable
05-12-08 - R ESERVED :