Operating instructions

TransTel TD-1648i / TDS-600 Programming Manual

Form 09-nnn-DP - System Speed Dial

General:

This program permits the assignment of up to 500 sets of system speed dialing codes.

Description:

nnn = 100-599 = Speed dial code, up to 500 sets in total.

DP = 01-30 = Digit Pointer for telephone number.

30 digits per speed dial code.

tt = 01-10 = Pre-assigned CO line number.

Pre-Assigned CO Line:

Press the {Change} key to change or clear the Pre-assigned CO line number. This CO line is the dedicated

outgoing line for the speed dial code. If the user presses a speed dial code without selecting a CO line first, the

system will select this CO Line automatically. If no CO line is assigned, the system will select an available CO

line according to the assigned Dial 9 group (Program 41-nnnn-04). A line may also be selected directly by the

user.

Telephone Number:

30 digits maximum may be entered in each memory.

In addition to the digits 1 to 0, *, # the following can also be stored: Pause, Flash, Pulse to DTMF. Each function

occupies one digit.

"Pause" is represented by the [HOLD] key. -- P

"Flash" is represented by the [TRF/FL] key. -- F

"Pulse to DTMF" is represented by the {P->T} key. -- T

i) Pause:

During dial procedures on CO line, the dialing will pause for a programmable period (See Program 05-01-06).

During dial procedures on ISDN line, the dialing will wait for the called party answers the call.

For example,

Store 2961135ppp506 in speed dial and use this speed dial on CO line to dial out. System will dial DTMF

after three pause periods and send ‘506’ by using DTMF code.

ii) Flash : This will make a loop disconnection of a pre-assigned duration.

(Refer program mode 05-02-05).

iii) Pulse to DTMF : If the dialed signal is "pulse", it will change to "DTMF".

Note: Pressing {Don’t Care} will erase the digit which the cursor is on.

Pressing [REDIAL] will erase all the assigned digits.

Note: An indication of TK:00 will cause the system to utilize the first free line in a station's dial 9 group.

An indication of 01-08 will cause the system to always select the same CO Line.

Note: To enter a name, press the CHG (Volume Down) key until the letter "N" appears in the upper

right corner of the LCD display. Letters and numbers may be entered through the keypad. For

Dial by name to operate, 05-05-05 must be enabled.

Phone numbers may not exceed 30 digits in length (including special characters). Names may be entered up to

30 characters, but will only be displayed to 16 characters.