Operating instructions

TransTel TD-1648i / TDS-600 Programming Manual
99
Form 25 - Reset Data to System Default
This program resets all data to System Default. All new systems must be reset to default before any
programming in case corruption has been caused during handling or shipping. When using item 3 or 4
these must be done AFTER the system reset is performed.
General:
This program resets all data to System Default. All new systems must be reset to default before any
programming in case corruption has been caused during handling or shipping. It will also be necessary to reset
to default after a software upgrade is installed. When using item 3 or 4 these must be done AFTER the system
reset is performed.
Description:
1 = System data will be reset to system default except System Speed Dial Programming.
2 = The system data will be totally reset to system default.
WARNING: All user-defined data will be lost.
3 = For all Stations set
44-st-02=1 (Hold Feature restricted)
44-st-03=1 (Call Split Feature restricted)
This feature is for Hotel/Motel operation. After setting this Mode it is necessary to reprogram the
Console and any Administration phones in Mode 44-st-02 to allow them to place calls on hold.
4 = For all stations set
40-st-01=0 (Barge In not allowed)
40-st-02=0 (Monitor not allowed)
It is strongly recommended that this parameter is used on ALL systems to prevent accidental
Barge In operations being misinterpreted as cross talk.
All other system programming information remains unchanged when using 3 or 4.