Use and Care Manual

En.8 DK2 Everest R-3 man.

ENGLISH

Pre-InstallaƟon

The InstallaƟon should be completed on an asphalt/concrete surface, with suĸĐient area to work. Un-

package your new FRISTTRAX Snowplow, discard all shipping materials, recycle if possible. Once the plow is

un-packaged, slowly roll the plow from its upright shipping conĮguƌĂƟon over onto the built-in cart. Top up

the oil reservoir to ƚŚĞĮůůůine indicated with the 1L of hydraulic oil provided. Your new FIRSTTRAX Snowplow

is now ready to be installed.

InsƚĂůůĂƟon

Step 1 – Install mounƟng brackets and cross bar.

Please follow the instrucƟons included in your mount kit. Fit in place with all fasteners (Įnger Ɵght) then

proceed to Ɵghten with appropriate tools.

Step 2 – Install the main power cord.

**ALWAYS EXERCISE CAUTION WHEN USING HAND TOOLS AROUND THE BATTERY! A SOLID

CONDUCTER SUCH AS A METAL WRENCH CAN CAUSE SEVERE INJURY, FIRE, OR EVEN CAUSE THE

BATTERY TO EXPLODE!

AƩach the short lead on the breaker to the posiƟve “+” terminal of the baƩery. Secure the breaker to the

fender orĮƌewall with the use of screws or zip Ɵes in a place where it will not come into contact with the

nĞŐĂƟǀe terminal. AƩach the negaƟve lead to the negĂƟve “-“baƩery terminal. Route the wires from the

baƩery in the best possible way to

the front of the vehicle avoiding areas that can become hot or cause

friĐƟon when the vehicle is in use. Zip Ɵe the wires to the vehicle’s structure so that they do not move or

shiŌ when in operaƟon. ConĮrm the breaker is in the closed posiƟon, and then close the hood slowly to

make sure

et a

ain that the wires are clear from

inch

oints.

INSTALLATION STEPS