User guide

34
net isp dhcp discover duration A parameter to enable DHCP retries. This param-
eter is in units of seconds and sets how long after
a DHCP timeout that the ATA will restart sending
DHCP discovers.
0 (Disabled)
net isp connect on demand en-
able
Enable PPPoE or PPTP connection on demand Disabled
net isp connect on demand
interval
Idle period for disconnection in seconds 0
net isp keep alive enable Keep PPPoE or PPTP connection active when
enabled
Disabled
net isp keep alive interval Interval for keep alive messages in seconds 0
net isp save as assigned Enable saving of results acquired automatically as
the assigned address, netmask and gateway for
later restarts. When this is enabled the ATA saves
the IP information (IP address, netmask, gateway,
DNS servers) obtained from a DHCP response in the
appropriate parameters (‘net static ip address’,
‘net static netmask’, ‘net static gateway address’,
‘net dns primary address’, ‘net dns secondary ad-
dress’)
net isp reconnect on link
loss
Enable automatic reconnection on link loss (re-
tainsinitialcongurationifdisabled),CURRENTLY
NOT IMPLEMENTED n/a
Disabled
Remote Access Conguration:
Parameter Description Default
ata web external server en-
able
Enableaccesstoconguration
procedures from external IP ad-
dresses
Enabled
ata web internal server en-
able
Enableaccesstoconguration
procedures from local IP ad-
dresses
Enabled
ata web server port Portnumberforconguration
web server
0 (Defaults to 80)
ata web server language Language selection English
ata telnet server enable Enable remote access via telnet
protocols
Enabled
ata telnet port Telnet Port no
ata ftp server enable Enable remove access via ftp
protocols
Enabled
ata ftp port FTP Port no
NAT Transversal Parameters:
Parameter Description Default
nat stun enable
2
Enables use of STUN for discov-
ery of network address transla-
tion (NAT) mapping
Enabled