User manual DLE61

5
Installation Instructions
Prepare the engine for installation
1. Check to see that all screws and bolts are tight. Check carefully
for any cracks, broken, or missing parts. Tighten or replace any
damaged or missing parts before proceeding.
2. Install the silicone wire cover over the pick up lead coming from
the motor (cut the excess silicone wire cover) and connect the lead
to the pick–up lead from the Electronic Ignition Module. Secure
the connection with the included three pin connector securing clip.
3. Connect the manual on/off switch lead to the red connector from
the electronic ignition system using the lead from the kill switch or
with the included three pin connector with pig tail. Use one of the
included three pin securing clips to secure the connection.