Instruction Manual

2
Parts List
(1) DLE-35RA Gas Engine with DLE Carburetor
(1) CM6 Spark Plug with Spare Ignition Wire Spring
(1) Muffl er w/Gasket
(2) 5x15mm SHCS with 5mm Lock Washers (muffl er mounting)
(1) Electronic Ignition Module w/ Additional Tachometer Lead
(4) 60mm Engine Mounting Standoffs
(4) 4x40 mm SHCS with 4mm Lock Washers & Flat Washers (propeller mounting)
(4) 5x20 mm SHCS with 5mm Flat Washers (mounting engine to standoffs)
(1) Silicone Pick-up Wire Cover / Ignition Wire Cover
(1) Red Three Pin Connector Lead w/ Pig Tail (for ignition switch)
(2) Three Pin Connector Securing Clips
(1) DLE Decal
(4) 5x25 mm SHCS with 5mm Washers
(2) 20x 60mm White Exhaust Tubes with Clamps (not pictured)
Safety Tips and Warnings
● This engine is not a toy. Please place your safety and the safety of
others paramount while operating. DLE will not be held responsible
for any safety issues or accidents involving this engine.
● Operate the engine in a properly ventilated area.
● Before starting the engine, please make sure all components
including the propeller and the engine mount are secure and tight.
It is strongly recommended that a screw sealant is used (Great
Planes Threadlocker GPMR6060) during engine installation.
● During the break-in period, it is recommended that the engine be
installed on the aircraft or a test stand with an appropriate shock
absorber. Otherwise it is probable that vibration could rebound