User's Manual

Rev 1.1 (September 2017) 5  DLP Design, Inc.
6.1.2 Press and hold button 1. While holding button 1 press and release RESET.
Continue to hold button 1 until you hear the beep. Release button 1 and the system will be
transmitting at 2.4GHz on the internal chip antenna with no modulation.
**** Be sure to turn the volume up (blue knob next to speaker) if you cannot hear the beep.
**** You can change to the external antenna by pressing button 2 - ANT-SEL. The display
will show C for chip antenna and W for whip antenna.
**** You can change the carrier frequency to 2.44GHz by pressing button 5 (L-M-H).
Repeatedly pressing the L-M-H button will cycle through the Low (2.41GHz), Medium
(2.44GHz) and High (2.48GHz) carrier frequencies.
6.2 For CW mode - with modulation - LORA mode
6.2.1 Press Button 1 until LORA mode is selected:
6.2.2 Press and hold button 3. While holding button 3 press and release RESET.
Continue to hold button 3 until you hear the beep. Release button 3 and the system will be
transmitting at 2.4GHz on the internal chip antenna with LORA modulation.
6.3 For CW mode - with modulation - FLRC mode
6.3.1 Press Button 1 until FLRC mode is selected:
6.3.2 Press and hold button 3. While holding button 3 press and release RESET.
Continue to hold button 3 until you hear the beep. Release button 3 and the system will be
transmitting at 2.4GHz on the internal chip antenna with FLRC modulation.
6.4 For CW mode - with modulation
- GFSK mode
6.4.1 Press Button 1 until GFSK mode is selected: