User's Manual

Rev 1.1 (April 2009) 4 © DLP Design, Inc.
6.0 REGULATORY AGENCY CONSIDERATIONS
6.1 AGENCY IDENTIFICATION NUMBERS
Compliance with the appropriate regulatory agencies is essential in the deployment of all
transceiver devices. DLP Design will obtain modular approval for this RF product such that an
OEM need only meet a few basic requirements in order to utilize their end product under this
approval. Corresponding agency identification numbers will be listed below:
Part Number US / FCC CANADA / IC
DLP-RFID-
UHF1B
SX9UHF1B 5675A-UHF1B
6.2 EXTERNAL ANTENNAS
The DLP-RFID-UHF1B will be approved for use with selected external antennas. Connection is
made via reverse-polarity SMA connectors.
A magnetic loop antenna is provided with each DLP-RFID-UHF1B reader purchased from DLP
Design as shown below:
This antenna is well suited for reading the near-field loop incorporated into many Gen-2 tags.
This antenna requires a coax cable with a reverse-polarity SMA connector at one end for
connection to the DLP-RFID-UHF1B reader. A 3-foot coax cable is provided with each DLP-
RFID-UHF1B reader purchased from DLP Design.
6.3 FCC/IC REQUIREMENTS FOR MODULAR APPROVAL
Any changes or modifications to the DLP-RFID-UHF1B’s printed circuit board or magnetic loop
antenna could void the user’s authority to operate the equipment.
6.4 WARNINGS