Operation Manual

Example 2.

Two fullrange speakers connected in stereo

bridge mode to front and rear channels, CH1-

2 & 3-4.

One subwoofer to CH5

NOTE!

The subwoofer output is 2 ohm stable. Two 4 ohm

subwoofers can be connected in parallel.

Speaker wiring RA50

RA50

HP-filter: in OUT position the amplifier allows the

speakers to play fullrange. If you for some reason

want to limit the low bass reproduction switch IN

the HP-filter. The typical setting is then around 60 –

80 Hz.

LP-filter = OUT

Bottom plate switch: position x1

Filter settings CH1 - CH2

Front speaker pair connected in bridge mode

Filter settings CH5

Filter settings CH3 - CH4

HP-filter: in OUT position the amplifier allows

the speakers to play fullrange. If you for some

reason want to limit the low bass reproduction

switch IN the HP-filter. The typical setting is then

around 60 – 80 Hz.

Bottom plate switch: position x 1

LP-filter: 60-80 Hz

Subsonic filter: position IN

For GRAND BASS and PHASE settings,

see page 8.