User manual

39 Chapter 5
Hard Disk Boot Priority
Set hard disk boot device priority.
CPU Thermal Monitor
The Intel Thermal MonitorAutomatic Mode. There are two Automatic
modes called Intel Thermal Monitor 1 (TM1) and Intel Thermal Monitor
2 (TM2). And IPPC-9070 Auto dete C-M or P-M.When CPU was C-M
BIOS running in TM1,another running TM2.
TM1: When Intel Thermal Monitor 1 is enabled, and a high temperature
situation exists, the clocks will be modulated by alternately turning the
clocks off and on at a 50% duty cycle. Cycle times are processor speed
dependent and will decrease linearly as processor core frequencies
increase. After the temperature has returned to a non-critical level, modu-
lation ceases and the TCC goes inactive.
TM2: When Intel Thermal Monitor 2 is enabled, and a high temperature
situation exists, the processor will perform an Enhanced Intel SpeedStep
technology transition to a lower operating point. When the processor tem-
perature drops below the critical level, the processor will make an
Enhanced Intel SpeedStep technology transition to the last requested
operating point. Intel Thermal Monitor 2 is the recommended mode on
the Intel Pentium M processor
Enabled (default) Enable Thermal Monitor
Disabled Disable Thermal Monitor
Virus Warning
During and after the system boots up, any attempt sector or partition table
of the hard disk drive will this happens, a warning message will be dis-
played. anti-virus program to locate the problem. If the Virus disabled, no
warning message will appear if anything access the boot sector or hard
disk partition.