Specifications

Rev10 (November 10, 2006)

The specificati

on item name was changed.

1-3.”Storing Temperature” to “Storage Temperature”

1-3.”Storing Humidity” to “Storage Humidity”

1-4.”Operating Load” to “Activation Force”

1-4.”Light Transmissivity” to “Light Transmittance”

1-4.”Top Surface Hardness” to “Surface Hardness”

2-3.”Operating Load Test” to “Activation Force Test”

2-3.”Operating Load” to “Activation Force”

3-1.”Operationg Load” to “Activation Force”

1-4.Operating Force is changed “0.5N±0.3N” to “0.05N to 0.8N”.

1-5.Insulation Resistance is changed “Over 100MΩ at 25V” to “Over 20MΩ at 25V”.

1-6.Tip, crack: Deleted “Applied only in the Active Area. Scratches or dusts in the outside of the Active

Area are acceptable unless the electrical characteristics are affected.”.

2-3. § Operating Life Test (Pen) Load: 300g to 250g

5-5. § Cushion: Added an installation position of a cushion.

7.Added Revision History.

Rev11 (March 23, 2010)

1-6. Appearance specification was revised. Characters of scratch/dust were classified into Circular and

Linear. The total acceptable number of scratch/dust was added.

2-3. Unit of Load (g) changed to (N) to unify the unit

2-3. Operating Life Test (Finger) Activation Force, Within ±50% of the specification → Must satisfy

the specification. (Clerical error was corrected)

2-3. Operating Life Test (Pen) Activation Force, Within ±50% of the specification → Must satisfy the

specification. (Clerical error was corrected)

3-1. Temperature Condition Cold Test -30℃→ -40℃ (Clerical error was corrected)

3-1. Activation Force, Within ±50% of the specification. → Must satisfy the specification

(Clerical error was corrected)

Data Modul AG - www.data-modul.com