Specifications
G150XG01 
V3  rev  1.0 
4/28
1. Operating Precautions 
1) 
Since front polarizer is easily damaged, please be cautious and not to scratch it. 
2)  Be sure to turn off power supply when inserting or disconnecting from input connector. 
3)  Wipe  off  water  drop  immediately.  Long  contact  with  water  may  cause  discoloration  or 
spots. 
4)  When the panel surface is soiled, wipe it with absorbent cotton or soft cloth. 
5)  Since the panel is made of glass, it may be broken or cracked if dropped or bumped on 
hard surface. 
6)  Since CMOS LSI is used in this module, take care of static electricity and insure human 
earth when handling. 
7)  Do not open nor modify the module assembly.   
8)  Do not press the reflector sheet at the back of the module to any direction.   
9)  In case if a module has to be put back into the packing container slot after it was taken 
out  from  the  container,  do  not  press  the  center  of  the  LED  Reflector  edge.  Instead, 
press at the far ends of the LED Reflector edge softly. Otherwise the TFT Module may 
be damaged. 
10)   At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor 
tilt the Interface Connector of the TFT Module.   
11) TFT-LCD Module is not allowed to be twisted & bent even force is added on module in a very 
short time. Please design your display product well to avoid external force applying to module 
by end-user directly. 
12) Small amount of materials without flammability grade are used in the TFT-LCD module. The 
TFT-LCD module should be supplied by power complied with requirements of Limited Power 
Source (IEC60950 or UL1950), or be applied exemption. 
13) Severe temperature condition may result in different luminance, response time. 
14) Continuous operating TFT-LCD Module under high temperature environment may accelerate 
LED light bar exhaustion and reduce luminance dramatically. 
15) The  data  on  this  specification  sheet  is  applicable  when  TFT-LCD  module  is  placed  in 
landscape position. 
16) Continuous  displaying  fixed  pattern  may  induce  image  sticking.  It’s  recommended  to  use 
screen saver or moving content periodically if fixed pattern is displayed on the screen. 
Data Modul AG - www.data-modul.com
5










