User manual

V Panel 104 / 121 / 150 / 170 / 190 User Manual

3.1.3 USB port

This connector provides two external USB 2.0 interfaces

3.1.4 Parallel port LPT

Use this port to connect a printer or other parallel devices.

3.1.5 Serial Interface COM1, COM2, COM3

Three serial interfaces enables you to connect a external device with 9 pin

DSUB connector such as mouse or modem. COM2 is selectable as a input for

programming fielbuscontroller.

3.1.6 Fieldbus interface CAN / CANOpen / Profibus / DeviceNet

External connector of internal fieldbus controller. Interface to connect CAN,

CANOpen, Profibus/MPI or DeviceNet devices. All interfaces in master or

slave configuration available.

3.1.7 CRT Monitor

Connector and interface to VGA/CRT monitor .

3.1.8 Second LAN2 Port

This connector provides a second external interfaces 10/100/1000 BaseT on

RJ45 connector to your panel to other devices in a network.

3.1.9 Reset

Reset Switch reset the hole unit.

3.1.10 Main power IN

Use this connector to connect the power supply of 24VDC. Please note the

Power requirements (See chapter technical details).

3.1.11 Power ON button

Enables you to switch on and off the main system.

3.1.13 Front USB

Use this port behind a cover to connect USB devices direct on the panel front