User manual

http://www.kontron.com
21
Werner-von-Siemens Str.1
D - 93426 Roding
Tel: [phone] - 0
Fax: [phone] - 100
After complete installation and calibration of touch you find a new icon in the
control panel to set additional features.
4.2.2 Install EC1 fieldbus driver
Basically your system is perpared as one of the possible fieldbus interfaces.
That means that the firmware of the controller inside is programmed, and the
needed fieldbus module is mounted.
To get access from your operating system to this controller you had to install
the so called CIF device driver.
You find this driver on the provided Hilscher system software CD in the folder
DRIVER.
Start installation with program SETUP.EXE at this folder.