MSDS

MSDS Report NO.: AKS0905251001K Date: May 27, 2009 Page 3 of 6
This Test Report is issued by the Company subject to its Conditions of Issuance of Test Report printed overleaf or attached. The results shown in this Test
Report refer only to the sample(s) tested unless otherwise stated and such sample(s) are retained for 30days only. This Test Report shall not be
reproduced expected in full, without written approval of the Company.
Section 4 - First Aid Measures
Skin touch: If battery is leaking and material contacts the skin, remove any contaminated clothing and flush exposed skin with
copious amounts of running water for at least 15 minutes. If irritation, injury or pain persists, seek medical attention.
Eyes touch: If battery is leaking and material contacts the eye, flush thoroughly with copious amounts of running water for 30
minutes. Seek immediate medical attention.
Inhalation: If battery is leaking, contents may be irritating to respiratory passages. Move to fresh air. If irritation persists, seek
medical attention.
Ingestion: If battery contents are swallowed, do not induce vomiting. If the victim is alert, have them rinse their mouth are the
surrounding skin with water for at least 15 minutes. Seek immediate medical attention.
Section 5 - Fire Fighting Measures
Danger characteristic: Batteries may burst and release hazardous decomposition products when exposed to a fire situation.
Hazardous combustion products: Thermal degradation may produce hazardous fumes of zinc and manganese; hydrogen gas,
caustic vapors of potassium hydroxide and other toxic by-products.
Fire-Fighting method & media: Firefighters should wear positive pressure self-contained breathing apparatus and full
protective clothing. Fight fire from a distance or protected area. Cool fire exposed batteries to prevent rupture. Use caution when
handling fire-exposed containers (containers may rocket or explode in heat of fire).
Section 6 - Accidental Release Measures
Notify safety personnel of large spills. Caustic potassium hydroxide may be released from leaking or ruptured batteries. Clean-up
personnel should wear appropriate protective clothing to avoid eye and skin contact and inhalation of vapors or fumes. Increase
ventilation. Carefully collect batteries and place in an appropriate container for disposal.
Section 7 - Handling and Storage
Avoid mechanical or electrical abuse. DO NOT short circuit or install incorrectly. Batteries may explode pyrolize or vent if
disassembled, crushed, recharged or exposed to high temperatures. Install batteries in accordance with equipment instructions.
Do not mix battery systems, such as alkaline and zinc carbon, in the same equipment. Replace all batteries in equipment at the
same time. Do not carry batteries loose in a pocket or bag. Do not remove battery tester or battery label.
Storage: Store batteries in a dry place at normal room temperature. Do not refrigerate- this will not make them last longer.
Section 8 - Exposure Controls, Personal Protection
Maximum admissible concentration: No standard yet.
Ventilation: No special ventilation is needed for normal use.
Respiratory Protection: None required for normal use.
Skin Protection: None required for normal use. Use neoprene, rubber or latex gloves when handling leaking batteries.
Eyes Protection: None required for normal use. Wear safety goggles when handling leaking batteries.