Specifications

® 2011 - 2 - User manual 0025
1.1 Safety instructions
Information for Your Own Safety
This manual does not contain all of the safety measures for operation of this
equipment (module, device) because special operating conditions, local code
requirements or local regulations may necessitate further measures. However, it
does contain information which must be adhered to for your own personal safety and
to avoid damage to the equipment. This information is highlighted by a warning
triangle with an exclamation mark or a lightning bolt depending on the severity of
the warning.
Warning
Means that failure to observe the instruction can result in death, serious injury or
considerable material damage.
Caution
Means hazard of electric shock and failure to take the necessary safety precautions
will result in death, serious injury or considerable material damage.
Qualified personnel
Installation and operation of the equipment described in this manual may only be
performed by qualified personnel.
Only people that have proper knowledge about the local standards regarding
electrical installations and are allowed to work on these installations according to
the local regulations are considered qualified personnel in this manual.
Use for the intended purpose
The equipment (device, module) may only be used for the application cases
specified in the catalog and the user manual and only in connection with devices
and components recommended and approved by Inepro Metering B.V.
Proper handling
The prerequisites for perfect, reliable operation of the product are proper transport,
storage, installation and connection, as well as proper operation and maintenance.
When operating electrical equipment, certain parts of this equipment carry
dangerous voltages. Improper handling can therefore result in serious injury or
material damage.
 Only use isolated tools suitable for the voltages the meter is used for.
 Do not connect while the circuit is energized (current is running).
 Place the meter only in dry surroundings.
 Do not mount the meter in an explosive area or exposed to dust, mildew
and/or insects.
 Make sure the used wires are suitable for the maximum current of this meter.
 Make sure the AC wires are connected correctly before activating the
current/voltage to the meter.
 Do not touch the meter’s connection clamps directly with your bare hands,
with metal, blank wire or any other conducting material as that will cause an
electric shock and possibly cause injury.
 Make sure the protection cover is placed after installation.
 Installation, maintenance and repair should only be done by qualified
personnel.