User's Manual

CB Series PC104 Plus User’s Manual Software Installation
Loading the Driver
After setting up the driver, you must load the driver in order to gain access to the serial ports on
the module. Run BIN\DPC-DRV.EXE at the DOS prompt. The driver will detect your CB Series
module automatically. You should see messages indicating successful detection of your module,
such as the following:
Smartio/Industio Family DOS driver Version 1.8
Setup driver …
CB-114 series (Bus=x, Dev=y) : OK!
Device driver setup O.K.
At this point, you can execute applications that support API-232 functions, or start developing
applications using the API-232 library.
Unloading the Driver
To unload or release the CB Series driver from memory, enter DPC-DRV/Q at the DOS prompt.
Windows CE 5.0
In this section, we explain how to install Moxa CB series boards under WinCE 5.0. These
instructions are intended for users who are familiar with the Windows CE Platform Builder 5.0
Toolkit, and would like to install one or more Moxa Tech products. Here, we only give the
step-by-step installation instructions for the development environment. You will need to download
the image file to the target host yourself.
The WinCE 5.0 driver for the Moxa CB Series PC/104-Plus Multiport Serial Module supports the
following products:
y CB Series: CB-108, CB-114, CB-134I
The CB-114 board is used to illustrate the installation procedure.
Installing the driver
The following procedure explains how to install the CB-114 multiport serial module driver under
WinCE.
1. Obtain a copy of Moxa Tech WinCE 5.0 driver package and extract it to your computer.
Double click the Install package to copy the Mxser folder to
%WINCEROOT%\PLATFORM\ automatically, and import the supported MOXA Tech
products into the Folder.
3-54