Installation Guide

AIMS Fast-Scan Radar v3.22 Installation and Operations Manual
DMT, LLC • DMT-M200-311 • 08/2009
56
o SerialPort
 COMM Port
 BaudRate
 DataBit
 StopBit
 Parity
 Cam Address.
o TCPIP
 IPAddress
 Port
• Offsets.
o Look Offset – Az. This offset value defines the azimuth angle difference between
the home pins of the radar and the camera (see drawing below).
o Look Offset – El. This offset value defines the difference in degrees between the
camera look angle (at 0º elevation) and the horizon (up is positive).
o Position Offset – Az. This offset value defines the location (in degrees
clockwise) the camera is positioned relative to the radar home pin.
o Position Offset – Rng. This offset value defines the absolute distance the camera
is positioned relative to the radar (in meters).
o Height. This offset value defines the height the camera is positioned above the
ground.
• IP Address (Video). The IP address of the video codec/server that digitizes the camera’s
output video stream (usually inside the UCM).
• Camera Array. This selection is used to support a very specific application involving
four cameras installed at 90º angles and communicating on a single multidrop serial
communications line. More detail may be found in the DMT document, “Camera
Alignment and Operation Procedures for AIMS EA-System” (dated 1/23/2008).