User's Manual

DIGITAL-LOGIC AG MSM855/HLV/B/B2 Detailed Manual V1.0A
91
X12 FAN-Power Supply, 2pin
Pin Signal Pin Signal
1 VCC5 2 GND
X13 FAN-Power Supply 1, 3pin
Pin Signal Pin Signal
1 GND P2 VCC12V **
3 FAN1IN* * for future use / ** only if 12V on X8 pin 4
X16 FAN-Power Supply 2, 3pin
Pin Signal Pin Signal
1 GND 2 VCC12V **
3 FAN2IN* * for future use / ** only if 12V on X8 pin 4
7. JUMPER LOCATIONS ON THE BOARD
The following figures show the location of all jumper blocks on the MSM855 board. The numbers shown in
the figures are silk screened on the board so that the pins can easily be located. This chapter refers to the
individual pins for these jumpers. The default jumper settings are written in bold.
Be careful: some jumpers are soldering bridges; you will need a miniature soldering station with a vacuum
pump.
Settings written in bold are defaults!
Jumper Structure 1-2 / open 2-3 / closed Remarks
J16
Main switch manually set
1-2 = Automatic
power on
2-3 = ATX-Switch (push button)
must be connected to GND
(press button for boot up)
J10
Only for manufacturer's use
J11
Only for manufacturer's use
J32


LAN onboard function
Enabled
Disabled
 only available on the MSM855B/B2
For the jumpers of board Version 0.4 please refer to Chapter 13, Previous Product Versions.