Specifications

Page | 28
Marquee Technical Guide - Version 6.3.9 – 040511 DMX ©2010 All Rights Reserved
Additional Resources
Unlike the products above that DMX has extensive experience with in our lab, the products
below are presented in good faith and believed to be correct, however since DMX has not tested
these products in house, we can make no representations or warranties as to the completeness
or accuracy of all the information. Our limited experience with these products is positive and we
feel may be helpful in certain circumstances, and the information is supplied for people to make
their own determination as to its suitability for their purposes prior to use. In no event will DMX
be responsible for damages of any nature whatsoever resulting from the use of or reliance upon
Information or the product to which Information refers.
Video Extension Products
The Hall Research UH-1C is used to extend
HDMI™ audio/video signal to 200ft @
1080i/720P or 150ft @ 1080p on 1 Cat6
cable. Quality Cat5e cables can also be
used, however when Cat5e is used the max
distances are reduced by about 33%.
The UH-1C supports HDMI™ version 1.2a.
Two power supplies are needed for the
setup. The remote receiver re-aligns the
pixel clock and generates a clean pixel clock
for the display, thereby taking out any skew
that may have been induced in the cable.
The Re-clocking feature of the UH-1C allows
the units to be daisy-chained together to
extend the video and audio even farther
Note: Cables that are of lower quality and
construction will also reduce the maximum
distance.
Hall Research‟s UV232A-4S is a 4 channel
Video, Audio and RS-232 over UTP
(Cat5/5e/6) sender. The UV232A-4S can
transmit Video, Audio and RS-232 to
compatible receivers (such as Hall Research
Models URA-232 and URA 232 XT) up to
1,000 feet away. The UV232A-4S supports
resolutions up to 1920 x 1200 at 60Hz
The Hall Research URA-232 is a video, audio and
uni-directional RS-232 over UTP receiver. The
receiver is located at a distance from the AV/RS-
232 source and connected to a compatible UTP
sender or extender. The URA-232 has a digital
input configurable as "Contact" or "Voltage". User
defined serial strings can be sent depending on
the state of the digital input and also remotely
from a compatible UVA-232-4 (see above) or
UVA-232-8 sender or via serial command. Using
the remote capability, you can have URA-232 and
URA-232-XT units daisy chained and talk to all the connected devices serially with each sending
the same or completely different serial strings.