User's Manual

- 14 -

Use the opening lever to open the lock, and

then pull out the mechanism unit�

Lift the paper lever and raise the front cover�

Hold the center of the scrap box and lift it

up straight�

Printer Installation

Caution

• Do not apply too much strength when pulling the mechanism unit out� If detached, the

mechanism unit may fall and cause an injury or damage to surrounding objects�

• Never remove the scrap box diagonally� The scrap box may be damaged and the product

may not operate normally�

• When the scrap box has been removed, do not touch the cutter on the upper part or you

may be cut�

• In order to facilitate color adjustment, media type recognition, and print quantity

management, an IC chip is included in the ink ribbon� Note that a ribbon with an IC chip that

has not been evaluated and approved may not function properly� (If correct data cannot be

read from the IC chip, an alarm will sound� In such a case, ink concentration levels will be

lowered in order to protect the product�)

Setting the media (paper, ribbon)

Opening lever

Front cover

Scrap box

Paper Lever

Mechanism unit