User's Manual

- 23 -

The printer stopped with the paper partially cut

Set the ON/Standby switch to Standby and then ON again�

The paper jam is released and the cutter blade returns to its standby position�

Remove the partially printed part of paper from the printer�

Next, refer to “The printer is jammed with paper” (see P�21)�

The power has been cut during printing

If the power is cut during printing, you will not be able to pull out the mechanism unit�

Set the ON/Standby switch to Standby and then ON again�

The partially printed paper is cut into scrap-size pieces and removed� After this,

you can pull out the mechanism unit�

Check that no partially printed paper remains in the printer�

If partially printed paper remains, refer to “The printer is jammed with paper” (see P�21)�

• If you cannot release the paper, contact a service representative�

Caution

• Do not set the ON/Standby switch to Standby during printing� This may cause a malfunction�

Troubleshooting