User's Manual

- 9 -

Caution for installation

• Before using the product, read “For Safe Operation” carefully and observe the instructions

therein�

• Use care when moving the product� Never try to carry the product alone� Dropping it may cause

injury or property damage�

• Do not use or store the product near a fire, humid places, in direct sunlight, near an air

conditioner or heater, or any other location with unusually high or low temperature, strong

humidity, or excessive dust�

• Do not place the product where chemical reactions occur, such as in a laboratory�

• Do not install the product where there is salinity or corrosive gas in the air�

• The product must be installed on a rm, level surface where there is ample ventilation.

• Do not put anything on top of the product�

• Do not use the product near a radio or television, and do not use the same wall outlet for the

product and a radio or television� Otherwise radio or television reception may be adversely

affected�

• Do not use a power voltage or a frequency other than those specied.

• Do not put anything on the power cord or step on it�

• Do not drag or carry the product by the power cord or the USB cable�

• Avoid plugging the power cord into an outlet with many other cables connected�

• Do not bundle the power cord�

• Always grip the plug housing, not the cord, to plug or unplug the power cord�

• Always unplug the power cord before connecting or disconnecting the USB cable�

• Avoid using a long USB cable or connecting it to any noise-producing device� If it is unavoidable,

use a shielded cable or twisted pair for each signal�

• Use a shielded USB cable compatible with the USB 2.0 specications.

• Place the product near the outlet where the power cord can be unplugged easily to shut the

power off�

• Use an AC outlet that accepts a three-pronged plug� Otherwise, there may be a danger of

electric shock�

• Do not use the cord set supplied with the printer for other devices�

• Use the cord set supplied for the product�

• This product is not intended for use in the immediate/direct visual eld of the display work place.

To avoid disturbing reections on the display work place, this product shall not be placed in the

immediate/direct eld of vision.

• Use as a network printer is not anticipated�

Any use in conjunction with a network will be the

customer’s sole responsibility�